Edwin’s enthusiasm for boat building reaches back many years into his childhood. “I think I can honestly say that everywhere there was a boat, I had my nose into it somehow,” he explained. Edwin grew up in Heart’s Delight…

The distinction between a punt and a rodney, or if there is even a distinction to be made, is often debated among boat builders and enthusiasts. Both punts and rodneys are…

Built over winter 2011-2012, her knees were taken from a juniper (tamarack) tree that was uprooted during Hurricane Igor. All the wood for this rodney was harvested…

Stewart’s grandfather Peter Sturge was born in 1888 on Flowers Island in Northern Bonavista Bay. His great-grandfather participated in the inshore cod fishery and land-based seal hunt, an economy that was in decline by the time…

Each spring, Jack Casey of Conche would set out in his rodney and row twelve to fourteen miles to the Grey Islands in search of seals. "It was a long row,” he remembered. “The worst part was…”

When building boats, Jack Casey uses a set of moulds that once belonged to his grandfather, Michael Casey. When Michael Casey arrived in Conche in 1850, he made a set of moulds which he…

John (Jack) Thomas Casey was born on July 2, 1922 in Conche, a small fishing community on Newfoundland’s Northern Peninsula. One of eight children born to Michael and Nora Casey, Jack started working in the lumber woods at only seven years old and…

The three-piece mould is an old method for designing and building boats. A lot of the first boats to come off our beaches and take to the fishing waters were boats built with these curved sticks of wood. The method was…

David A. Taylor describes the three-piece mould method used by boatbuilders in Winterton, Trinity Bay. Similar to whole-moulding, Taylor describes these moulds as, “a wooden, three-piece adjustable template used to draw the shapes of…